文章摘要
王敏慧,鲍善惠.粗细端等长阶梯形变幅杆的有限元分析[J].,2005,24(5):275-280
粗细端等长阶梯形变幅杆的有限元分析
Finite element analysis of stepped ultrasonic transformer with equal-length sections
  
中文摘要:
      本文利用有限元分析软件ANSYS研究了一组粗细端截面积比不同的阶梯形变幅杆,得出了每个变幅杆的第一阶和第三阶谐振频率、粗细端分界面的相对位移和振幅放大系数。结果表明:ANSYS仿真值与实测值的平均偏差仅为0.3%,远小于常用式解析值与实测值的偏差;变幅杆粗细端分界面的运动类似受牵引的薄膜运动;而振幅放大系数与面积比成正比的结论可扩展到粗细端截面积比为100的情况。
英文摘要:
      Finite element method (FEM) is used, through software ANSYS, to analyze stepped ultrasonic transformers, the two sections of which have the same length but different cross-sectional areas. The resonance frequency, the displacement pattern of the interface between the two sections, and the amplitude amplifications of the first-and the third-order vibration modes are computed for each transformer. The results show that the average deviation (0.3%) between the ANSYS simulated frequencies and the experimentally measured values is much less than that between the frequencies calculated from the conventional formula and the experimental; the movement of the section interface of the transformer is similar to that of a towed membrane; a linear relationship between the amplitude amplification and the cross-section-area ratio is obtained, which applies to the later ratio as high as 100.
DOI:10.11684/j.issn.1000-310X.2005.05.003
中文关键词: 阶梯形变幅杆  有限元分析  ANSYS  局部共振
英文关键词: Stepped ultrasonic transformer  FEM  ANSYS  Local resonance
基金项目:陕西师范大学重点科研基金(995004)
作者单位
王敏慧 上海船舶电子设备研究所
上海 200025 
鲍善惠 陕西师范大学应用声学研究所
西安 710062 
摘要点击次数: 2095
全文下载次数: 589
查看全文   查看/发表评论  下载PDF阅读器
关闭