文章摘要
高子洋,师芳芳,张碧星,苏业旺.卷积神经网络的缺陷类型识别分析*[J].,2022,41(2):301-309
卷积神经网络的缺陷类型识别分析*
Recognition and analysis of defect types by convolutional neural network
投稿时间:2021-03-26  修订日期:2022-03-01
中文摘要:
      本文提出一种基于卷积神经网络直接对阵列超声检测原始信号进行缺陷类型识别的方法,该方法无需对超声回波原始信号进行特征提取。文章研究对比了不同卷积神经网络及其优化的识别性能。首先采用超声相控阵系统对不同试块上的平底孔、球底孔、通孔三种缺陷进行超声检测,然后利用LeNet5、VGG16和ResNet三种卷积神经网络对一维和二维数据分别进行缺陷识别,并使用Leaky ReLU、Dropout、Batch Normalization等来对网络进行优化,对比分析识别准确率和效率等。研究结果表明,虽然一维卷积在训练速度上快于二维,但是二维卷积在识别准确度方面更高,同时网络模型结构如果过于复杂会导致准确率的下降,数据增强和优化方式有助于加快收敛速度、提高准确率。
英文摘要:
      In this paper, a method of the defect type recognition based on the convolutional neural network is proposed by the original signal from the array ultrasonic testing. The method does not require feature extraction of the original ultrasonic echo signals. The recognition performance and optimization characteristic of different convolutional neural networks are studied and analyzed. Firstly, the experiments are conducted by the ultrasonic phased array system to collect detection signals which comes from the flat-bottom hole, spherical-bottom hole and via hole. Then, Lenet5, VGG16 and Resnet convolutional neural networks are used to identify the defects in one and two dimensions, and the network is optimized by Leaky ReLU, Dropout and Batch Normalization respectively. Subsequently, the identification accuracy and efficiency are analyzed. It is shown that 2-d convolution has higher recognition accuracy although its training speed is slower than that of 1-d convolution. At the same time, the identification accuracy will decline if the network model structure is too complex, and the data enhancement and optimization methods can help to accelerate the convergence speed and improve the accuracy.
DOI:10.11684/j.issn.1000-310X.2022.02.017
中文关键词: 卷积神经网络  超声检测  缺陷类型识别  
英文关键词: convolutional neural network  ultrasonic testing  defect type recognition  
基金项目:
作者单位E-mail
高子洋 中国科学院声学研究所 gzy6368@163.com 
师芳芳* 中国科学院声学研究所 fangfangshi@mail.ioa.ac.cn 
张碧星 中国科学院声学研究所 zhbx@mail.ioa.ac.cn 
苏业旺 中国科学院力学研究所 yewangsu@imech.ac.cn 
摘要点击次数: 639
全文下载次数: 535
查看全文   查看/发表评论  下载PDF阅读器
关闭